基于影响因子的消费品质量安全管理

分析了我国消费品质量安全在研究领域以及现实管理中存在的问题,引入消费品质量安全影响因子的概念,研究了影响因子与伤害事故之间的作用机理,阐述了影响因子研究的基本方法,论证了消费品质量安全影响因子管理在提升产品品质、维护消费者权益及强化政府监管等方面的意义。     

脱硫石膏粒径分布与脱水性能实验研究

脱硫石膏粒径分布是影响脱硫石膏浆液脱水性能的重要因素之一，以干法、湿法筛分和研磨破碎获得不同粒径分布的脱硫石膏，在相同的过滤条件下，对不同粒径分布脱硫石膏浆液脱水性能进行了研究，实验结果表明，当脱硫石膏粒径d50大于50μm且（d90-d10）小于100μm，真空过滤最大真空度不低于0．098MPa，过滤时间不少于2．5min，滤饼厚度不超过20mm时，石膏滤饼含水率可以降低到12％以下（最低可达10％）；d50在17μm为脱硫石膏在相同的过滤条件下能够实现真空脱水干燥的转折点；d50和（d90-d10）共同影响石膏脱水性能，d50小于20μm时，仅表现为d50的影响。     

苯胺-邻氨基酚共聚物对水中Hg(Ⅱ)吸附性能的研究

利用化学氧化法合成了苯胺-邻氨基苯酚的共聚物,并通过静态实验研究了材料对水中汞离子的吸附性能。研究结果表明,该共聚物对废水中汞离子有优异的去除效果,其吸附容量可达212.13 mg/g;吸附等温线符合Langmu ir单层吸附模型,动力学过程符合准二级动力学模型;溶液pH值对吸附影响不是很大,pH 5~10范围都有较好的吸附效果;氯离子易与汞离子形成水溶性更强的络合物,对共聚物的吸附有很大的抑制作用。     

Characteristic, composition, and sources of TSP investigated by HRTEM/EDS and ESEM/EDS

Total suspended particle (TSP) collected at the fifth floor of House Dust in Hunan University, China, was analyzed in terms of microscopic morphology and chemical composition. The fine particles (50?nm-2?μm) in the TSP were analyzed by a high-resolution transmission electron microscope equipped with an energy-dispersive X-ray analyzer (HRTEM/EDS). Results showed that the particles were in shapes of plate, irregular and agglomerate. Based on EDS results, these fine particulate matter was primarily composed of Fe-rich (35.82-61.29%), Ca-rich (30.18-36.77%) and Si-rich (18.95-32.28%) particles. Other elements mainly including Mg (0.47-4.97%), Al (0.45-14.57%), S (0.45-4.73%), K (1.13-2.13%) and Zn (0.67-3.85%) were also observed. The sources analysis indicated that the HRTEM particles mainly originated from coal combustion, traffic emission, vehicles exhaust emission and fugitive soil or cement particulate matter. The coarse particles (4-50?μm) were detected by environmental scanning electron microscopy coupled with energy-dispersive X-ray detector (ESEM/EDS). Based on a simple algorithm, ESEM particles were categorized into five groups: C-bearing (46.15%, 67% and 86.98%), Si + Ca-bearing (21.48?+?11.80%, 16.51?+?10.81% and 16.32?+?10.62%), Si + Al-bearing (20.06?+?12.40%, 20.16?+?11.22% and 15.31?+?11.25%), Si-bearing (34.40%, 26.92% and 27.15%) particles and aggregates, most of which exhibit obvious crystalline structure, and these ESEM particles mainly derived from vehicles exhaust emission, coal combustion, soil, and biomass burning, while the aggregates are indicative of atmospheric reaction progress. HRTEM/EDS and ESEM/EDS are mutual complementary in analyzing the characteristic and determining the sources of TSP.     

震害预测中建筑物属性信息提取方法研究

在编制城市抗震防灾规划工作中,如何得到规划区大量的建筑物的普查资料一直是一个重要的课题。就此,本文提出了一种基于RS技术通过首先旋转高分辨率遥感图像而后搜寻建筑物阴影区有效分割线段来实现大范围建筑物层数信息提取的新方法,并结合高分辨率遥感影像数据和实际建筑物层数信息对提取结果进行分析。结果表明计算模型正确,普适性较强,算法过程简单,所得结果精度满足城市震害预测基础信息的要求,有较大实用价值。     

响应面分析法优化稀土废水MAP沉淀法脱氮

经过预处理后的稀土生产废水，其氨氮浓度大幅降低，但并未达到中华人民共和国《稀土工业污染物排放标准》（GB26451-2011）中氨氮浓度限值。实验通过响应面分析法中的Box-Behnken实验设计（BBD），取pH、n（Mg）：n（N）、n（P）：n（N）3因素，采用Design-Expert 8.0.6，建立合适的剩余氨氮浓度及剩余总磷浓度模型，得到回归方程，并分析模型各项指标，各因素及其相互作用对剩余氨氮浓度及剩余总磷浓度的影响。利用预测模型预测最佳实验条件，在最佳实验条件下验证预测结果，并对沉淀物进行X射线衍射（XRD）分析。结果显示，二次响应模型适用于剩余氨氮浓度及剩余总磷浓度，2个模型均拥有较好的拟合程度、可信度及精密度，最优反应条件为：pH=9.88、n（Mg）：n（N）=1.50：1、n（P）：n（N）=1.38：1时，剩余氨氮浓度为46.58 mg/L，剩余总磷浓度为7.85 mg/L。在最优条件下所得到的沉淀物并非纯净的MgNH₄PO₄·6H₂O，还有Mg₃（PO₄）₂·22H₂O生成。     

高速公路路面沉积物的污染特性

对湖南省长潭西高速公路不同采样点的路面沉积物进行取样分析,并检测了样品的颗粒级配、COD、重金属(Cu、Zn、Pb和Cd)和有机质。结果表明,路面沉积物主要以粒径<0.15 mm的颗粒为主;较小颗粒物中的COD含量高于较大颗粒中的COD含量;粒径在0.15 mm以下的颗粒物所含重金属Cu、Zn、Pb和Cd的浓度普遍高于所选的土壤标准值,降雨一旦形成径流将会产生严重的污染危害;沉积物中的有机质含量对重金属的吸附有一定的影响,有机质含量越高,沉积物中重金属含量相对也高。     

Co-metabolic transformation of the neonicotinoid insecticide imidacloprid by the new soil isolate Pseudoxanthomonas indica CGMCC 6648

A new imidacloprid (IMI) degrading bacterium Z-9 (deposited number CGMCC 6648) was isolated and identified as Pseudoxanthomonas indica by 16S rRNA gene analysis. Two metabolites were identified as olefin and 5-hydroxy IMI by liquid chromatography-mass spectrometry and nuclear magnetic resonance analysis. P. indica CGMCC 6648 degraded 70.1% of IMI (1.22 mmol L^?1) and formed 0.93 mmol L^?1 5-hydroxy IMI and 0.05 mmol L^?1 olefin IMI in 6 days and in the presence of 100 mmol L^?1 glucose. The half-life of IMI degradation was 3.6 days. P. indica CGMCC 6648 transforms IMI via a co-metabolism mechanism and different carbohydrates have significant effects on 5-hydroxy IMI formation, whereas different organic acids have substantial effects on olefin IMI production. Lactose is the best co-substrate for IMI degradation and 5-hydroxy IMI formation with 0.77 mmol L^?1 degraded and 0.67 mmol L^?1 formed in 48 h, respectively. Pyruvate is the best co-substrate for olefin IMI formation with 0.17 mmol L^?1 produced in 96 h for all carbon sources tested. Pyruvate significantly stimulates the conversion of 5-hydroxy IMI to olefin IMI, whereas glucose slightly inhibits this reaction. P. indica CGMCC 6648 rapidly degrades IMI and forms olefin IMI, which may enhance its potential for biodegradation of IMI and increase its insecticidal activity, which can decrease the IMI dosage required.     

手工电弧焊接的劳动保护

随着经济的快速发展,从城市到乡村,从大企业到小型个体户的焊接加工部,从建筑高楼大厦到农民建造住宅,都在大量使用手工电弧焊接作业.     

浅议创新教育

创新教育是培养人具有创新能力的教育。创新教育是社会发展的必然选择;创新教育是教育发展的必然选择;创新教育是人类的发展的必然选择。创新教育以创新精神的培养为基础,以创新思维的培养为核心,以创新能力的培养为最终目标。